Parkside Performance 445977 2307 Traduction Des Instructions D'origine page 52

GB MT
must close securely over the handles.
4. Turn on the chainsaw.
A warning tone sounds.
­ The­indicator­(29)­for­the­inserted­
chain­brake­flashes
The chain brake functions.
5.­ Release­the­on/off­switch­(2).­
If the chain brake does not func-
tion correctly, you must not use
the chainsaw. A slack saw chain leads
to danger of injury. Return the chain-
saw to our Service-Center for repair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
•­ Switch­on­the­chainsaw­and­hold­it­
above a bright background. The saw
must not touch the ground.
If­an­oil­trace­can­be­seen,­the­chain-
saw is working trouble-free.
­ If­no­oil­trace­can­be­seen­clean­the­
oil passages or turn the chainsaw
to our Service-Center for repair.
Clean the oil passages of the chain
bar­(30),­in­order­to­guarantee­a­
trouble-free,­automatic­oiling­of­the­
saw chain during operation. Use
a brush or a cloth to help remove
residues from the oil outlet duct.
Changing the saw bar
1. Switch off the device and remove the
16)­from­the­device.
batteries (
2.­ Lay­the­saw­on­a­flat­surface.
3.­ Turn­the­fastening­bolt­(11)­and­the­
screw for the chain quick-tensioning
52
system­(12)­in counter-clockwise
direction in order to loosen the chain
tension and to remove the sprocket
chain­wheel­cover­(13).
4.­ Remove­the­saw­bar­(4)­and­saw­chain­
(6).­To­remove­the­guide­bar­(4),­raise­
it­to­an­angle­of­approx.­45­degrees.­
This will make it easier to take the saw
chain­(6)­off­the­sprocket­ (20).
5. Replace the blade and install the blade
and­chain­as­described­under­"Install-
ing the sawing chain and blade".
Approved blade bars:
Oregon­164MLE041(112329),
Trilink M1431656-1041TL.
Refer to the start-up section on how
to tension the saw chain.
Sawing techniques
General
Observe the noise protection and
local regulations when cutting
wood. Local requirements may
require a suitability test. Ask the
forestry commission.
•­ Dirt,­stones,­loose­bark,­nails,­staples­
and wire must be removed from the tree.
•­ For­sawing­work­on­a­slope,­always­
stand above the tree trunk.
•­ To­keep­control­at­the­moment­of­
"sawing­through",­reduce­the­contact­
pressure at the end of the cut without
loosening­the­firm­grip­on­the­chainsaw­
handles.­Ensure­that­the­saw­chain­does­
not come into contact with the ground.
•­ After­completing­the­cut,­wait­for­the­
chainsaw to come to a standstill before
removing the chainsaw.