Télécharger Imprimer la page

Parkside Performance 445977 2307 Traduction Des Instructions D'origine page 47

Publicité

•­ For­sowing­work­on­hillsides,­always­
stand in the area above the log. To
keep­total­control­while­sawing­through,­
reduce the pressure at the end of the
cut without loosening your grip on the
handles of the electric chain saw. Make
sure the saw chain does not touch the
ground.­After­finishing­the­cut,­wait­until­
the electric chain saw comes to a halt
before removing it. Always shut off the
engine of the electric chain saw before
switching between trees.
•­ Dirt,­stones,­loose­bark,­nails,­clips­and­
wires must be removed from the tree.
• Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock­or­fire.­
Residual risks
Even­if­properly­operating­and­handling­this­
electric­tool,­some­residual­risks­will­remain.­
Due­to­its­construction­and­build,­this­elec-
tric tool may present the following hazards:
a)­ Cuts
b)­ Ear­damage­if­working­without­
ear protection.
c)­ Damage­to­your­health­caused­by­
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning!­During­operation,­this­elec-
tric tool generates an electromagnetic
field­which,­under­certain­circumstances,­
may impair the functionality of active or
passive medical implants. To reduce the risk
of­serious­or­lethal­injuries,­we­recommend­
that persons with medical implants consult
their doctor and the manufacturer of their
medical implant before operating the ma-
chine.
Observe the safety information
and notes on charging and
proper use as shown in the instruc-
tion manual for your battery and
charger of the X 20 V Team series
from Parkside. A detailed description
of the charging process and further
information can be found in the sep-
arate operating instructions.
Charging
Do not expose the battery to
extreme conditions such as
heat and shocks. There is a risk of
injury caused by leaking electrolyte
solution! In case of contact with
eyes or skin, rinse the affected sites
with water or a neutralizer and
seek medical attention.
The battery must only be
charged up in dry areas. The
external surface of the battery must
be clean and dry before being con-
nected to the charger. There is a risk
of personal injuries from an electric
shock.
Only charge batteries of the
X 20 V Team­series­from­PARKSIDE
with­a­charger­of­the­X 20 V Team­series­
from PARKSIDE .
•­ Charge­the­battery­before­using­it­for­
the­first­time.
•­ Always­comply­with­the­latest­safety­
information,­as­well­as­the­regulations­
and information relating to environmental
protection.
GB
MT
47

Publicité

loading

Produits Connexes pour Parkside Performance 445977 2307

Ce manuel est également adapté pour:

Ppksa 40-li b2