O P E R A T I N G I N S T R U C T I O N S; Connection / Launch Of The Lipo Balancer; Launching The Balancer - Conrad Voltcraft Li-Po Balancer 1007 Notice D'emploi

O P E R A T I N G I N S T R U C T I O N S

Connection / launch of the LiPo balancer

Launching the balancer

DATA - LINK DATA - LINK
POWER ON POWER ON
/
Mode
CHARGER
FUSE
Lithium Polymer Ladegerät Lithium Polymer Ladegerät
Black
Schwarz
Red
Rot
The connections must be established in this sequence for launching:
1. Connection of sense line (1). The sense mass (usually black) must be connected with the connection
of the plug marked „G". Check the firm fitting of the plug.
2. Connect the charging plug of the battery with the correct polarity with the „LiPo PACK" connection (2)
on the balancer. (black = negative pole, red = plus pole).
3. Now press the „POWER ON / MODE" key (3) once. The LiPo balancer checks the battery pack and
displays the identified cells via the red display lights 1-7 (4) by flashing three times. If this does not
happen, there is an error such as a wrongly connected sense plug. This is displayed with the „STATUS
LED" status display. If there is a critical error which can result in damage, the balancer cannot be
switched on for safety reasons.
(3)
STATUS-LED
(4)
7 6 5 4
LI-PO BALANCER 1007
Lithium polymer charger
max. 4.2V per cell
max. 4,2V pro Zelle max. 4,2V pro Zelle
max. 29.7V total
max. 29,7V gesamt max. 29,7V gesamt
max. 10A charging current
-
+
max. 10A Ladestrom max. 10A Ladestrom
(5)
G
3 2 1
LI-PO PACK LI-PO PACK
DATA-LINK
Data line
Datenleitung Datenleitung
for suitable charger only
(nur für passendes Ladegerät) (nur für passendes Ladegerät)
SENSE LINE
(1)
SENSELEITUNG
Battery
pack
Akkupack - Akkupack -
(2)
Battery
Akkupack + Akkupack + pack
Lithium polymer battery:
Lithium-Polymer-Akku: Lithium-Polymer-Akku:
2 -7 cells
2 - 7 Zellen, 2 - 7 Zellen,
Nominal voltage:
Nennspannung: Nennspannung:
3.7V per cell
3,7V pro Zelle 3,7V pro Zelle
SENSE MASS
SENSE-MASSE
19