Publicité
•
Once you have entered the file name, confirm by pressing the VAL key.
Open burst:
Allows you to choose a burst among many and to open it to display the values. At this level, you can obtain information on the acquisition burst, such as the
number of measurements, the date of acquisition, the sensor used, etc.
New free burst:
Allows you to start a new acquisition burst. If a burst is under way, you will be requested to save it.
Burst management:
Allows you to display all the bursts recorded. At this level, you can delete one or all bursts.
Statistics:
Allows you to find out the number of bursts recorded, the number of bytes free as well as the number of measurements which can be recorded.
D.5.1
Synthesiser configuration
D.5.1.1
Configuration of synthesiser points
The configuration of the synthesiser points is identical to that of the default values.
D.5.1.2
Configuration of synthesiser parameters
The configuration of the synthesiser parameters is performed in the configuration/Synthesiser/Parameters menu, obviously providing the Synthesiser mode
has been confirmed.
Careful, the values (points) must be recorded first
•
Once you have selected the configuration/Synthétiseur/ Paramètres (configuration/Synthesiser/Parameters) menu, confirm by pressing the
VAL key.
This screen allows you to configure the emission:
First point:
st
This is the 1
point to be emitted. It is not necessarily the 1
Last point:
This is the last point to be emitted. It is not necessarily the last point in the table of values but this point number must be below the number of points recorded.
Should this not be the case, it will be impossible to record the configuration of the synthesiser parameters
Duration:
This is the amount of time required for the emission of all the points that need to be emitted (Last point - first point).
Repetition:
st
point in the table of values.
D
63/63
Publicité
