Publicité
D.2
Differential measurements
The relative measurement function available on the device makes it possible to cancel a constant or spurious value via programming.
When the relative measurement function is enabled, the symbol
The NULL/define menu makes it possible to program the value of the Tare (positive or negative). This value is obtained from the measurements:
D.3
Calibrated sensors
The calibrated sensors function of the device makes it possible to use sensors, the calibration (correction) coefficients of which are taken into consideration by
the device during measurement.
•
Using the F1 key, enter the Configuration menu.
•
Select the Calibrated Sensors function, followed by one of the 5 available sensors.
•
Confirm (VAL key).
•
Enter the sensor information fields. Use the F1 function key (
is displayed on the measurement screen.
Value Displayed = Value measured – Value of the Tare
) to move from one field to the next.
Pictogram of the
TARE mode
D
57/57
Publicité
