SilverCrest SHBSB 800 A1 Instructions D'utilisation Et Consignes De Sécurité page 27

Trimming beards
Note that the desired trim length can only be
achieved if the product is held perpendicularly
to the skin's surface.
Comb the beard using the supplied comb
in its direction of growth.
Shorten the beard downwards from the ear to
the chin, one side after the other.
Use the cutting unit without the comb attach-
1
ment to trim the beard very short or to trim
11
a moustache or hairline.
Graduate the desired trim length by rotating
the lower part of the product
length position indicator
may be set to 5 different levels (0.8 mm/
1.1 mm/1.4 mm/1.7 mm/2.0 mm).
To trim a moustache, firstly comb it straight
downwards. Begin in the centre above the
mouth, then one side and then the other.
Cleaning and care
CAUTION! DANGER TO LIFE BY ELECTRIC
SHOCK! Pull the plug-in mains adapter
of the mains socket before cleaning the product.
Never touch the plug-in mains adapter
moist or wet hands, especially when you plug
it into the socket or pull it out of the socket.
Always keep the plug-in mains adapter
supply cord dry.
CAUTION! RISK OF PROPERTY DAMAGE!
Do not submerge the product in water or any
other liquid to clean it as the product is not
waterproof. This could damage the live parts
(rechargeable batteries).
Do not use any corrosive or abrasive cleaning
agents.
Clean the housing and the charging base
using a damp cloth and a mild detergent.
Switch the product off by pressing the ON/
OFF button once or twice, until the product
3
goes off.
Disconnect the supply cord from the product
and remove the plug-in mains adapter
the mains socket.
17
according to
5
. The trim length
4
out
7
with
7
and
7
6
from
7
Remove the comb attachment
attachment or the cutting unit
12
product (see Fig. G + H).
Wash the comb attachment
attachment or the cutting unit
12
ning water if necessary.
Dry the comb attachment
attachment or the cutting unit
12
Remove the cutting unit
Remove any remaining bits of hair from the
cutting unit using the cleaning brush
1
provided (see Fig. I).
Apply one or two drops of blade oil
between the blades and the moving parts
(see Fig. J).
Adjust the length position indicator
after you have finished cleaning the product,
before once more attaching the cutting unit
to the product (see Fig. K).
Note: Clean the cutting unit
ment and thinning attachment
11
every use.
Storage
Place the product in the charging base
you wish to store it. Alternatively, you can also
store it in the travel case
Note (regarding storage the product):
Do not put the product to direct sunshine or heat.
The ideal ambient temperature is between -10
and +60 °C. Extreme low or high temperature
may damage the battery or the product.
Troubleshooting
Error Cause
The product The battery
does not may not be
work. charged.
Trimming is Hair may
be stuck
difficult.
inside the
blades.
, the thinning
11
from the
1
, the thinning
11
with run-
1
, the thinning
11
.
1
(see Fig. H).
1
13
14
to 2.0 mm
4
1
, comb attach-
1
after
12
if
6
provided.
16
Solution
Recharge the
product.
Clean the cutting
unit and the
1
product and oil it if
necessary.
GB/IE 27