Place the product into the recess of the charg-
ing base
with the cutting unit
6
upwards.
Insert the plug-in mains adapter
socket which meets the product requirements.
Note: During the charging process, the red charg-
ing display
will light up and the battery status
9 b
display
will show the battery level.
10
Note: As soon as the battery is charged, the
battery status display
10
charging display
will continue to be red.
9 b
Note: You can use the product for up to approx.
60 minutes with a full battery without it being
connected to the power supply.
Note: When the battery is almost empty, the charg-
ing display
on the display will flash. Then, the
9 b
product may only be used for a short period of time
without being connected to the power supply.
Operating using the plug-in mains
adapter
:
7
If the product stops working during use due to an
empty or insufficient battery, you can continue if the
plug-in mains adapter
Insert the cable plug of the plug-in mains adapter
into the socket on the underside of the
7
product.
To avoid injuries and damage to the product,
always switch the product off before connecting
to the plug-in mains adapter
Insert the plug-in mains adapter
socket which meets the product requirements.
After a few seconds you can switch on the
product by pressing the ON/OFF buton
once or twice for the desired speed. If the
product does not start working immediately,
switch it off by pressing the ON/OFF button
once or twice until the product goes off. Wait
approx. 1 minute before you try to switch it on
again.
Oiling the blades
It is recommended that you oil the blades before
first use and after cleaning to guarantee complete
functionality (see Fig. E).
pointing
1
into a
7
will switch off, while the
is connected.
7
.
7
into a
7
3
Apply one or two drops of blade oil
tween the blades and distribute them evenly.
Wipe away any excess oil using a cloth.
You can also use any acid-free oil such as
sewing machine oil.
Note: The blades can be oiled with or without
comb attachment
Operation
Changing the attachments
Carefully place the desired comb attachment
onto the product as depicted in Fig. F. Ensure
that both recesses of the comb attachment
properly engage into the lateral detents at both
sides above the cutting unit
To remove the comb attachment
slide it forward and upwards using both thumbs,
as depicted in Fig. G.
Setting the trim length
To set different trim lengths, hold the upper
part of the product
part of the product
(0.8–2.0 mm). The set trim length will be displayed
on the length position indicator
with the dot-marking on the upper part of the
product
.
2
Trimming hair
Note: The hair being trimmed should be clean,
dry and untangled.
3
Carefully comb the hair using the supplied
comb
to disentangle any potential knots.
17
Place the hairdressing cape
neck and nape to prevent bits of hair from
falling into the collar.
Begin by using the longer comb attachment
and trim the hair gradually to the desired length.
Note that the desired trim length can only be
achieved if the product is held perpendicularly
to the skin's surface.
14
and thinning attachment
11
.
1
, press and
11
and twist the lower
2
into the desired position
5
which aligns
4
around the
15
GB/IE
be-
.
12
11
11
11
25