SilverCrest SHBSB 800 A1 Instructions D'utilisation Et Consignes De Sécurité page 24

immediately the affected areas
with fresh water and seek medi-
cal attention!
WEAR PROTECTIVE
GLOVES! Leaked or
damaged batteries/rechargea-
ble batteries can cause burns
on contact with the skin. Wear
suitable protective gloves at all
times if such an event occurs.
This product has a built-in re-
chargeable battery which cannot
be replaced by the user. The re-
moval or replacement of the re-
chargeable battery may only be
carried out by the manufacturer
or his customer service or by a
similarly qualified person in or-
der to avoid hazards. When dis-
posing of the product, it should
be noted that this product con-
tains a rechargeable battery.
ATTENTION! RISK OF
PRODUCT DAMAGE! Do not
expose the product to direct sun-
shine or heat. The ideal ambient
temperature is between 5 and
40 °C. Extreme low or high tem-
perature may damage the bat-
tery or the product.
No action is needed from users
to shift the product between 50
and 60 Hz. The product adapts
itself for both 50 and 60 Hz.
24 GB/IE
Before use
Note: The product may be powered using the
built-in rechargeable battery or the plug-in mains
adapter .
7
Remove all parts from the package.
Charging
Note: Before first use, the rechargeable battery
in the product should be charged for at least
90 minutes. A charging time of 90 minutes is also
required subsequently.
This product also has a quick charge function:
1 minute quick charge for over 3 minutes use.
The product can be charged directly or indirectly
by using the charging base
Note: The charging process is shown on the display
of the charging display
display .
10
Disconnect the product from the plug-in mains
adapter when the battery-status display
7
shows 100.
Note: Do not leave the product permanently
connected to the plug-in mains adapter
avoid damage to the battery or the product.
Direct charging (see Fig. C)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (Press the ON/OFF button
or twice, until the product goes off).
Insert the cable plug of the plug-in mains adapter
into the socket on the underside of the product.
7
Insert the plug-in mains adapter
socket which meets the product requirements.
Indirect charging (see Fig. D)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (Press the ON/OFF button
or twice, until the product goes off).
Connect the cable plug of the plug-in mains
adapter with the charging base
7
.
6
and the battery-status
9 b
7
once
3
into a
7
once
3
.
6
10
to