Publicité
•
Always reassemble the device
completely after replacing the
grinding disc.
Switch off the device and unplug
the mains plug.
Allow the device to cool down.
Use protective gloves when working
with grinding discs.
1. Unscrew the 3 mounting screws to the
grinding disc cover (5).
2. Remove the grinding disc cover (3).
3. Unscrew the grinding disc nuts (17a)
by hand.
4. Remove the grinding disc from the hold-
er (17).
5. Place the new grinding disc onto the
holder and manually screw on the
grinding disc nut.
6. Screw the grinding disc cover (3) back
on.
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut
7. Trial run: Always carry out a trial
run of at least 30 seconds duration
without load before carrying out your
first grinding procedure and after every
grinding disc replacement. Switch the
device off immediately if the disc is not
rotating smoothly, if considerable vi-
bration occurs or if you hear abnormal
noises.
Transport
• Always transport the device with one
hand on the grinding head (2) and the
other hand on the grinding base (8).
• Never carry the device by its connec-
tion cable.
Storage
• Store the device in a dry and dustproof
location and out of reach of children.
Grinding discs must be dry and
stored upright and should never be
stacked.
Waste disposal/envi-
ronmental protection
Return the tool, accessories and packag-
ing to a recycling centre when you have
finished with them.
Electrical devices do not belong in
domestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implemented.
Ask our Service-Center for details.
• Defective units returned to us will be
disposed of for free.
Replacement parts/
Accessories
Spare parts and accessories can
be obtained at
www.grizzly-service.eu
If you have issues ordering, please use the
contact form.
If you have any other questions, contact
the "Service-Center" (see page 33).
GB
IE
31
Publicité
