SilverCrest SPWD 180 I1 Mode D'emploi page 30

SilverCrest SPWD 180 I1
9. Troubleshooting
9.1 Nothing is indicated on the display
•
The CR2032 lithium batteries are empty. Replace the CR2032 lithium batteries with new ones
of the same type. Please note the instructions in the "Replacing the batteries" section.
•
The CR2032 lithium batteries are inserted incorrectly. Please note the instructions in the
"Replacing the batteries" section.
9.2 "Lo" is indicated on the display and the scales switch off
•
The CR2032 lithium batteries are almost empty. Replace the CR2032 lithium batteries with
new ones of the same type. Please note the instructions in the "Replacing the batteries" section.
9.3 "USEL" is indicated on the display and the scales switch off
•
An error has occurred and the diagnostic scales cannot perform the measurement. If this
happens, step off the tread (5) on the diagnostic scales and restart the measurement.
9.4 "Err" is indicated on the display
•
Your weight exceeds the maximum load capacity of 180 kg / 396 lb / 28 st. You should step
off the tread (5) of the diagnostic scales immediately to avoid damaging the scales.
9.5 "Err2" is indicated on the display
•
An error occurred during measurement. If this happens, step off the tread (5) on the diagnostic
scales and restart the measurement. Make sure that you are standing on the electrodes (6).
10. Maintenance/cleaning
Repairs are required if the diagnostic scales have been damaged in any way, for example if the
device housing is damaged, when liquids or objects have penetrated into the diagnostic scales or
when the product has been exposed to rain or moisture. Repairs are also necessary if the product
does not perform normally or if it has been dropped. If smoke, unusual noises or smells are noticed,
remove the batteries from the diagnostic scales immediately. If this occurs, the diagnostic scales
should not be used before they have been inspected by authorised service personnel. All servicing
work must be carried out by qualified specialist personnel. Never open the diagnostic scales housing.
Only use a clean, dry cloth for cleaning the device. Never use any corrosive liquids.
28 - English