Philips sonicare DiamondClear 9000 Serie Mode D'emploi page 13

Masquer les pouces Voir aussi pour sonicare DiamondClear 9000 Serie:

4 Gently keep the bristles placed on the teeth and in the

gumline. Brush your teeth with small back and forth

motion so the bristles reach between the teeth.

Continue this motion throughout your brushing cycle.

Note: The bristles should slightly flare. It is not

recommended to scrub as you would with a manual

Note: If you apply too much pressure, you will be

alerted by a change in vibration of the handle and the

brush head replacement reminder flashing amber.

5 To clean the inside surfaces of the front teeth, tilt the

brush handle semi-upright and make several vertical

overlapping brushing strokes on each tooth.

6 After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces

of your teeth and areas where staining occurs. You

can also brush your tongue, with the toothbrush

switched on or off, as you prefer.

Note: Your Philips Sonicare toothbrush is safe to use on

braces (brush heads wear out sooner when used on

braces) and dental restorations (fillings, crowns, veneers)

if they are properly adhered and not compromised.

To make sure you brush evenly throughout the mouth,

divide your mouth into 6 sections using the BrushPacer

feature. The BrushPacer divides the brushing time into 6

equal segments and indicates when you should move to

the next area. The segments are indicated with a brief

pause in vibration. The toothbrush automatically stops at

the end of the brushing session.

Note: Additional segments may be added when you use

the White+ or Gum Health Modes.

Your power toothbrush is equipped with 4 different

modes: Clean, White+, Gum Health and Deep Clean+.

Based on the smart brush head you use, the optimal

mode and intensity will be selected automatically by the