SilverCrest SSM 550 D1 Mode D'emploi page 17

Cleaning the motor block
1) Use a dry or no more than slightly moistened cloth to clean the plastic
surfaces.
2) When cleaning, always check that the contact switch in the fitting for the
blender
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.
3) Remove any possible residues on the underside of the motor block
dry cloth or a stiff-bristled brush only. Ensure that nothing can get in through
the ventilation openings of the appliance.
After cleaning
Allow all parts to dry well before reassembling and reusing the liquidiser.
Storage
1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the power cable
motor block
3) Store the blender in a cool and dry location.
Disposal
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the European guideline 2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations. Please
contact your waste disposal facility if you are in any doubt.
The packaging is made from environmentally-friendly material and can be dis-
posed off at your local recycling plant.
■ 14 │ GB │ IE │ NI
is not blocked by soiling residues. If you cannot dislodge any
around the cable retainer
.
with a
on the base of the
SSM 550 D1