SilverCrest SSM 550 D1 Mode D'emploi page 16

■ If this does not remove the soiling, you can separate the lower plastic part
of the blender
blender
Glass element
Sealing ring
Cutting blade
Plastic element
1) Remove the blender
2) Turn the plastic element
separated from the glass element
WARNING! RISK OF INJURY!
► Take care with the cutting blades
3) Clean both parts thoroughly in a mild soapy solution or in a dishwasher.
4) Refit the plastic element
Ensure that the sealing ring
SSM 550 D1
(with the cutting blades
:
from the motor block
of the blender
of the blender
is correctly fitted.
) from the the glass part of the
.
anticlockwise, so that it can be
of the blender .
. They are very sharp. Risk of injury!
onto the glass element
GB │ IE │ NI
.
│ 13 ■