Proxxon MicroMot 60 Manuel D'utilisation page 19

1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button simul-
taneously until it engages in the depression
on the spindle.
3. Loosen the sleeve nut
4. Remove the operational tool 3 if necessary
and insert a new one in the collet hole
5. Tighten the sleeve nut 2 while depressing
the lock button.
1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button simul-
taneously until it engages in the depression
on the spindle.
3. Unscrew the sleeve nut 2
4. Replace the collet 3
5. Screw on the sleeve nut while depressing
the lock button.
1. Slightly turn drill chuck 8 (Fig. 1) and simul-
taneously press lock button (5) until the lat-
ter engages.
2. Open chuck and change bit.
1. Push the non-reversible plug into the power
unit.
2. Switch the machine on or (Fig. 1) and set
the correct speed with the button .
3. Fig. 4 shows two typical methods for holding
MICROMOT 60. When working, ensure that
the tool is held firmly in order to guide the ro-
tating application tool in a controlled manner
without thereby blocking the ventillation slots.
4. If the unit overheats, switch it off and allow it
to cool for a few minutes.
The electronic speed regulation works only with
non-stabilized power units (e. g. all PROXXON
power units). If connected to a battery, the unit
will only run at max. speed.
Please do not dispose of the device in domestic
waste! The device contains valuable sub-
stances that can be recycled. If you have any
questions about this, please contact your local
waste management enterprise or other corre-
sponding municipal facilities.
Please note:
Every device is dirtied by dust when working.
Cleaning is therefore essential. To ensure a
long service life, however, the machine should
be cleaned with a soft cloth or brush after each
use.
Mild soap or other suitable cleaning agent may
be used in this context. Solvents or cleaning
agents containing alcohol (e.g. petrol, cleaning
alcohols, etc.) should be avoided, since these
can attack plastic casings.
The apertures required for cooling the motor
must always be kept free of dust and dirt.
For more detailed information on accessories,
please request our device catalogue from the
address specified on the last page in the war-
ranty information.
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever for
the safe and proper function of our devices
when using third-party bits and cutters!
- 19 -