Proxxon MicroMot 60 Manuel D'utilisation page 18

1 pc. MICROMOT 60, E, EF drill/grinder
1 pc. Operating instructions
1 pc. Spigot nut with steel clamping jaw
(only MM60, MM60/E)
1 pc. Drill chuck (only MM60/EF)
1. ON - OFF switch with speed control (MM
60/E-EF only)
2. ON - OFF switch
3. Power cable
4. Hook
5. Locking pin
6. Spigot nut with steel clamping jaw (only
MM60, MM60/E)
7. 20 mm fitting for mounting in drill stand
8. Drill chuck (only MM60/EF)
The PROXXON drilling and milling machine MI-
CROMOT 60/E/EF is the ideal tool for precise
drilling, milling, grinding, polishing, brushing,
rust removal, engraving, chasing and cutting.
For hobby electronics, model making, precision
mechanics, jewellery shops, opticians, arts, tool
and mould making.
For marking tools and cameras.
It can be used on steel, non-ferrous metals,
glass, wood, minerals and ceramics.
The drill spindle is supported in a precision ball
bearing which eliminates any play.
Excellent handling because of the pen-type
grip.
The machine is reliably driven by a high torque
motor. Type 60/E/EF is fitted with an electronic
speed regulator.
Length:
Weight:
Spindle collar:
- 18 -
approx. 220 mm
approx. 230 g
Ø 20 mm
Speed (60/E/EF):
Voltage:
Power consumption:
Noise level:
Vibration:
Please note that the sound and vibration mea-
surements in particular have been performed
with Proxxon bits and cutters. When using third-
party brands we cannot guarantee compliance
with the statements given here!
Attention:
• Never press the lock button while the device
is operating.
• Depending on the collet size, bits and cutters
may have a shaft diameter of max. 3.2 mm.
• Insert the tools are far as possible when
clamping. Ensure that the shaft of the tool
does not stand out more than 30 mm from the
collet. Excessively protruding shafts can
bend easily and contribute to poor concen-
tricity.
• Do not in any case use bits and cutters with
an arbour length of more than 55 mm!
• When storing the bits and cutters, make sure
they are reliably protected from damage!
• A correct and consistent speed achieves a
high grinding performance, not excessive
contact pressure!
• By tendency: Bits and cutters with smaller di-
ameters require higher speeds than those
with a larger diameter.
5000 to 20 000 rpm
12 to 18 V
approx. 40 W
≤ 70 dB (A)
≤ 2,5 m/ s
2