Publicité
ENGLISH
SKIRT HEIGHT AND OPERATION CHECK
Preliminary procedure
1.
Empty the hopper (as shown in the User Manual), because the weight of the waste inside the hopper can affect the skirt height
check.
2.
Drive the machine on a level ground that is suitable for checking the skirt height.
3.
Engage the parking brake with the pedal (76) and the lever (69).
4.
Turn the ignition key (68) to "0".
Side skirt check
5.
Release the fasteners (8 and 6), then open the right and left door (7 and 5).
6.
Check the side skirts (A, Fig. 19) for integrity.
Replace the skirts when they have cuts (A, Fig. 20) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt
replacement, refer to the Service Manual).
7.
Check that the distance from the ground of the side skirts (A, Fig. 19) is within 0 – 3 mm (see Fig. 21).
If necessary, loosen the screws (B, Fig. 19) and adjust the skirt position. Then tighten the screws (B).
Front and rear skirt check
8.
Remove the main broom, as shown in the relevant paragraph.
9.
Check the front (A, Fig. 22) and rear skirts (B) for integrity.
Replace the skirts when they have cuts (A, Fig. 20) larger than 20 mm or cracks/tears (B) larger than 10 mm (for skirt
replacement, refer to the Service Manual).
10.
Check that the front (A, Fig. 22) and rear (B) skirts rub slightly on the fl oor and are not completely detached from it (see Fig.
24).
If necessary, loosen the screws (C, Fig. 22) and adjust the skirt position. Then tighten the screws (C).
11.
Press the front skirt lifting pedal (75) completely, and check that the front skirt lifts 5 cm approximately.
Release the pedal and check that the skirt does not remain in an intermediate position but returns to its initial position. If
necessary, adjust the skirt lifting cable (A, Fig. 23) with the adjuster (B) on the left front side of the skirt (for the front skirt
control cable replacement, see the Service Manual).
Reset
12.
Assemble the components in the reverse order of disassembly.
Figure 19
Figure 22
26
USER MANUAL
S311431
S311432
146 1062 000(3)2007-02 A
Figure 20
Figure 23
SR 1300H B
S311400
Figure 21
S311433
Figure 24
S310038
S310039
Publicité
