Publicité
ENGLISH
PANEL DUST FILTER CLEANING AND
INTEGRITY CHECK
NOTE
Besides the standard paper fi lter, polyester fi lters are
also available. The following procedure is applicable
to each type of fi lter.
1.
Drive the machine on a level ground and engage the
parking brake with the pedal (76) and the lever (69).
2.
Turn the ignition key (68) to "0".
3.
Open the hood (22) and secure it with the support rod (37).
4.
Disconnect the battery connector (25).
5.
Release the fasteners (A, Fig. 12) and remove the dust
fi lter cover (B).
6.
Disconnect the connector (A, Fig. 13) from the fi lter shaker.
7.
Unscrew the knobs (B, Fig. 13) and remove the fi lter
mounting frame (C).
8.
Remove the dust fi lter (D, Fig. 13).
9.
In an outdoor area, clean the fi lter by shaking it on a level
and clean surface, tapping the side (A, Fig. 14) opposite to
the wire gauze (B).
Complete the cleaning procedure by using compressed
air (C) at maximum 6 Bar, blowing only from the side
protected by the wire gauze (B), at a minimum distance of
30 cm.
Check the fi lter body for tears.
Moreover, according to the fi lter type, observe the following
cautions:
•
Paper fi lter (standard): Do not use water or detergents
to clean it, otherwise it can be damaged.
•
Polyester fi lter (optional): For a better cleaning, it is
allowed to wash the fi lter with water and non-lathering
detergents. This provides better quality cleaning but
reduces the life of the fi lter, which will have to be
replaced more frequently. The use of inadequate
detergents can damage the fi lter.
10.
If necessary, clean the fi lter compartment rubber gasket
(A, Fig. 15) along its perimeter and check it for integrity. If
necessary, replace it.
11.
Assemble the components in the reverse order of
disassembly, and note the following:
•
Install the fi lter with the wire gauze (B, Fig. 14) facing
upwards.
24
USER MANUAL
146 1062 000(3)2007-02 A
SR 1300H B
Figure 12
Figure 13
Figure 14
Figure 15
S311425
S311426
S311399
S311427
Publicité
