EUFY RoboVac X8 Hybrid Manuel Du Propriétaire page 15

English
5. Select a cleaning mode to start cleaning.
RoboVac automatically sweeps and mops in the selected mode.
6. When RoboVac finishes working and returns to the Charging Base, remove the
water tank, empty any remaining water, and clean the mopping cloth to prevent
mildew or unpleasant smells. The disposable mopping cloth is for single-use only. For
how to clean and maintain the water tank, refer to the "Cleaning and Maintenance"
section in this manual.
Use Your RoboVac with Amazon Alexa /
the Google Assistant
Amazon Alexa and the Google Assistant are smart voice assistants that enable you to
control RoboVac with your voice.
Before you start, make sure that:
• RoboVac is attached to the Charging Base to ensure there is enough power.
• RoboVac is connected with the EufyHome app.
• You have an Alexa-enabled device (i.e. Amazon Echo, Echo Dot and Amazon Tap,
Echo Show, Echo Spot) or a device enabled with the Google Assistant (i.e. Google
Home, Google Home Mini). These devices are sold separately.
• The Amazon Alexa app or Google Home app is already installed on your smart
device, and you have created an account.
To control RoboVac with Amazon Alexa or the Google Assistant
1. Open the EufyHome app and tap "Smart Integrations" in the top left.
2. Follow the on-screen instructions to complete the setup.
Currently this feature only supports English, German, French, and
Spanish. You can check regularly if more languages are supported at
https:/ /www.eufylife.com/support/.
26 EN
Set Up Virtual Wall
(Available on the App Only)
In the EufyHome app, you can set up a "No-Go Zone" or "Virtual Wall" as a restricted area.
This eliminates the need to use physical barriers, including Boundary Strips. This feature is
only designed for dividing the cleaning zones, not for isolating hazardous areas.
• No-Go Zone: RoboVac will not enter the zone to vacuum.
• Virtual Wall: RoboVac will not cross the virtual wall.
• To set a virtual wall, RoboVac must initially perform a cleaning run to
create a floor plan.
• Although a virtual wall is set, RoboVac may still enter the restricted zone
due to repositioning failure or abnormal sensors.
• Moving the device or changing the environment may lose the virtual wall
and cause mapping to fail and rebuild.
Cleaning and Maintenance
Before cleaning and maintaining, turn off the device and unplug the adapter.
For optimal performance, follow the instructions below to clean and maintain RoboVac
regularly. The cleaning / replacement frequency will depend on your RoboVac usage
habits.
Recommended Cleaning / Replacement Frequency
RoboVac Part Cleaning Frequency
Dust Collector After each use
Filter Once every week
Rolling Brush Once every week
Side Brush Once every month
Brush Guard Once every month
Sensors Once every month
Charging Pins Once every month
Swivel Wheel Once every month
Water Tank After each use
English
Replacement Frequency
-
Every 3 months
Every 6-12 months
Every 3-6 months (or when
visibly worn)
Every 3-6 months (or when the
silicone rubber strip on the brush
guard becomes visibly worn)
-
-
-
-
EN 27