EUFY RoboVac X8 Hybrid Manuel Du Propriétaire page 11

English
• Install the Charging Base in a location that RoboVac can easily access.
It is recommended to place the Charging Base against a wall, and on a
hard-level surface rather than on rugs or carpets.
• Always keep the Charging Base plugged in, otherwise RoboVac will not
automatically return to it.
• To ensure proper charging, do not frequently move the Charging Base.
When its location is changed, RoboVac may remap due to repositioning
failure (see About Your RoboVac > Map Navigation and Management
for details).
Charge Your RoboVac
• Make sure RoboVac is fully charged before use.
• RoboVac will return to the Charging Base at the end of a cleaning cycle or when its
battery is running low.
Method 1: Attach RoboVac to the Charging Base by aligning its charging pins with the
charging pins on the base.
Method 2: Press on the main unit or tap the
RoboVac to the Charging Base.
18 EN
icon in the EufyHome app to send
• If RoboVac is not used for a long time, to preserve the battery's lifespan,
recharge at least once every 6 months.
• When RoboVac is being charged, to enter Reduced Power Standby mode
for power-saving, simultaneously press and hold the three buttons (
& & ) on RoboVac for 10 seconds until the lights turn off. Wi-Fi
is disabled while this mode is active. Press
Standby mode.
Auto Recharge and Resume
RoboVac returns to the Charging Base automatically to recharge when:
• RoboVac has finished cleaning;
• Cleaning is not complete and the battery level becomes low; once recharged to
80% battery capacity, RoboVac will resume and finish the remaining cleaning.
Do not move the Charging Base during cleaning, otherwise RoboVac may
fail to return for recharge. If failed, you have to manually attach it to the
Charging Base. If the Charging Base is moved, start cleaning from the new
location. RoboVac will automatically return when it has finished cleaning.
Using Your RoboVac
Turn On / Off
• RoboVac turns on automatically when attached to the Charging Base and connected
to power.
• When RoboVac is not on the Charging Base, press and hold
turn on the main unit. Wait until the Power Status Light turns solid blue.
• When RoboVac is not on the Charging Base, press and hold
to turn off the main unit.
Start Cleaning
RoboVac cannot start cleaning if the battery level is low. In this case,
recharge RoboVac first before cleaning.
English
to exit Reduced Power
for 3 seconds to
for 3 seconds again
EN 19