Publicité
Les langues disponibles
Les langues disponibles
EN
5.5.1
Power supply control unit
- Verify that the power supply to the control unit is separately fused (10 A
maximum).
1. Route the mains cable through the right cable gland into the control
unit.
2. Connect the phase to terminal L1 (F).
3. Connect the neutral conductor (E).
1
Fig. 11: Connecting the control unit
6. Switch on the on-site power supply.
26
TankControl 10
Mounting
2
3
4
4. Grease the seal with the
5. Close the control unit.
5
enclosed grease.
- Verify that the lower part
of the housing and the
upper part of the housing
are correctly mounted.
Publicité
