Publicité
Les langues disponibles
Les langues disponibles
EN
2.2
Intended use
This product may only be used for measuring the level of the following media:
•
Grey water as per EN 12056-1
•
Fuel oil EL as per DIN 51603-1 and as per DIN SPEC 51603-6 with
5 - 100 % fatty acid methyl ester (FAME) as per EN 14214
•
Diesel fuel as per EN 590 with up to 7 % fatty acid methyl ester (FAME)
as per EN 14214
•
Biodiesel with up to 100 % fatty acid methyl ester (FAME) as per
EN 14214
•
Paraffinic fuels (such as HVO/GTL as per DIN/TS 51603-8) proportion-
ately with 0 - 100 %
Any use other than the application explicitly permitted in these operating
instructions is not permitted and causes hazards.
Verify that the product is suitable for the application planned by you prior to
using the product. In doing so, take into account at least the following:
•
All directives, standards and safety regulations applicable at the installa-
tion site of the product
•
All conditions and data specified for the product
•
The conditions of the planned application
In addition, perform a risk assessment in view of the planned application,
according to an approved risk assessment method, and implement the
appropriate safety measures, based on the results of the risk assessment.
Take into account the consequences of installing or integrating the product
into a system or a plant.
When using the product, perform all work and all other activities in conjunc-
tion with the product in compliance with the conditions specified in the oper-
ating instructions and on the nameplate, as well as with all directives, stand-
ards and safety regulations applicable at the installation site of the product.
4
TankControl 10
Information on safety
Publicité
