Dentsply Sirona Midwest RDH Freedom Mode D'emploi page 15

17. Symbol Identification
The following standard symbols appear on the device label.
Class II Equipment
Class II
Equipment
Type B applied part
MEDICAL EQUIPMENT
WITH RESPECT TO ELECTRIC SHOCK, FIRE AND MECHANICAL HAZARDS ONLY IN
ACCORDANCE WITH UL-2601-1/60601-1, CAN/CSA C22.2 NO.601.1
Consult instructions for use
Sterilizable up to the temperature specified
135
Do not re-use (For DPAs)
Do not re-use
Dispose of in accordance with the Waste Electrical and Electronic Equipment Directive 2002/96/
EC of the European Parliament and the Council of the European Union
IPX0
Protection Class IPX0
IPX0 Classification of ingress of water for Charger – not protected
IPX1
Footswitch not for operating theatres
Protection Class IPX1
IPX1 Classification of ingress of water
IPX3
Protection Class IPX3
IPX3 Classification of ingress of water for Inner Module - Protected against falling spray.
Duty Cycle for handpiece:
5 min
5 minutes ON
25 min
25 minutes OFF
Serial Number
Batch Code/Lot Number
LOT
This symbol is a mandatory marking for devices entering the European market to indicate conformity
with the essential health and safety requirements set out in European Directives. The symbol may be
accompanied by a four-digit identification number of the notified body.
Direct Current (DC) supply. 5 Volts, 1 Amp
5V-1A
Polarity of power (DC). Positive counter.
Do Not Autoclave (Inner Module)
ENGLISH • 14