Olimpia splendid DOLCECLIMA 10 HP WI-FI Mode D'emploi Et D'entretien page 45

b. This mode can be selected by pressing B7 or SW2 until when the ventilation LED
(S5) is activated on the control panel display.
c. In this operating mode, the internal fan is always on and it is possible to select the desired speed through
the keys B6 or SW6; the respective LEDs "High" (S1) or "Low" (S2) light up.
3.8 - HEATING MODE (HEAT)
a. The appliance heats the environment in this mode.
This mode can be selected by pressing B7 or SW2 until when the heating LED (S3b) activates on the
display of the control panel.
b. The temperature set-point (Set temperature) can be adjusted from 16°C to 31°C with 1°C variations thanks
to B4/B5 or SW3/SW4 and the respective value appears on the display.
c. After three minutes (maximum) from the activation of this operating mode, the compressor activates and
the appliance starts to supply heat.
d. Connect the condensation discharge pipe (paragraph 2.6).
3.9 - SLEEP MODE
• This function is not available while the Dehumidification (DRY) and Fan Only (FAN) modes are active.
a. This mode can be selected by pressing B3 or SW7; the "Sleep mode" LED (S7) activates on the display
of the control panel. The appliance will decrease (when cooling) or increase (when heating) the set tem-
perature by 1°C (1 or 2 F) for 1 hour.
b. To stop the function, press key (B3) on the remote controller; the LED (S7) switches off.
After a few seconds that the function is active, the control panel display (21) ad the front display
(24) switch off automatically.
The fan speed is set automatically at "Low" (S2) and it cannot be modified.
3.10 - TIMER MODE
To activate the appliance SWITCHING ON timer, work as follows:
a. With the appliance in stand-by mode (with the power plug connected), press the keys B2 or SW5.
b. When the LED S6 flashes, set the desired time value through the keys B4/B5 or SW3/SW4
(0h (Timer off) ---> 1h ---> 2h ---> .. 24h ---> 23h ---> 22h ---> .. 0h (Timer off) ---> ..).
c. The LED S6 remains steady on.
d. The appliance will switch on automatically when it reaches the previously set time.
To activate the appliance SWITCHING OFF timer, work as follows:
a. With the appliance switched on (LED S8 active), press the keys B2 or SW5.
b. When the LED S6 flashes, set the desired time value through the keys B4/B5 or SW3/SW4
(0h (Timer off) ---> 1h ---> 2h ---> .. 24h ---> 23h ---> 22h ---> .. 0h (Timer off) ---> ..).
c. The LED S6 remains steady on.
d. The appliance will switch off automatically when it reaches the previously set time.
3.11 - SWING FUNCTION
a. When the appliance starts, the flap (23)opens completely.
b. By pressing the "SWING" key B8 or SW8, the flap starts to swing automatically.
c. Press the key "SWING" B8 or SW8 to stop the flap in a certain position.
Press it again to restart oscillation.
EN - 15
DOLCECLIMA 10 HP WI-FI