Olimpia splendid DOLCECLIMA 10 HP WI-FI Mode D'emploi Et D'entretien page 44

3.4 - USE OF THE APPLIANCE
Work as follows in order to use the appliance.
To prevent possible damages to the compressor, each start is delayed by 3 minutes with
respect to the last switching off.
3.4.a - Preliminary operations
• Place the appliance on a stable and not inclined base, at at least 50 cm. from the wall
or from any other object, in order to ensure the correct air circulation. Place it on a
water-resistant surface since the possible water leakage could damage furniture or
the floor.
• Do not place the appliance directly on carpets, towels, blankets or other absorbent
surfaces.
• Insert the plug in the power socket; the appliance emits a "beep", displays the room
temperature, the S0 LED lights up with a fixed light, while the S10 ED flashes; the
appliance switches to stand-by mode.
Before electrically connecting the appliance, make sure the plate data correspond to
those of the electricity distribution network.
3.4.b - Appliance switching on/off
a. The appliance can be switched ON or OFF for short periods by pressing B1 on the remote control or
SW1 on the control panel (if the appliance is switched off for a long period then it should be deactivated
by removing the plug from the mains supply.
b. In case of prolonged stop of the appliance, it must be reset by removing the plug from the power socket,
wait 5÷10 seconds and then reinsert it; a beep signals that the appliance is ready for use.
To set the automatic switching on/off of the appliance, please refer to the paragraph "Timer Mode".
3.5 - COOLING MODE (COOL)
a. Using this mode, the appliance dehumidifies and cools the environment.
This mode can be selected by pressing B7 or SW2 until when the cooling LED (S3a) is activated on the
control panel display.
b. The temperature set-point (Set temperature) can be adjusted from 16°C to 31°C with 1°C variations thanks
to B4/B5 or SW3/SW4 and the respective value appears on the display.
c. Three minutes (maximum) after the activation of this operating mode the compressor starts and the ap-
pliance starts to distribute cold air.
3.6 - DEHUMIDIFICATION MODE (DRY)
a. This mode can be selected by pressing B7 or SW2 until when the dehumidification LED (S4) is activated
on the control panel display.
b. In DRY mode, it is not possible to select the fan speed or to adjust temperature.
The fan motor works at low speed.
c. Keep doors and windows closed to achieve the best dehumidifying effect.
Do not place the air outlet pipe out of a window.
d. Connect the condensation discharge pipe (paragraph 2.5).
3.7 - VENTILATION MODE (FAN)
a. When this operating mode is used the appliance has no effect on the temperature or humidity of the en-
vironment, it merely circulates the air.
EN - 14