Christopeit Sport HUDSON Instructions De Montage Et D'utilisation page 17

TRANSPORT UND LAGERUNG
1. The rowing machine can be folded up and stored upright.
To do this, position the seat (76) at the rear end of the seat
carriage, grasp the center support (21) and slowly pull it up
until the rowing machine is folded up and upright. The rowing
machine can now be easily moved. Attention! Be aware of
the risk of crushing when folding and unfolding.
CLEANING, CHECKS AND STORAGE
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use
benzene, thinner or other aggressive cleaning agents for surface
cleaning as this damage caused. The device is only for private
home use and for use suitable indoors. Keep the unit clean and
moisture from the device.
2. Storage
To change the installation location, lift the rear of the device so that
it rests on the transport wheels. You can store the device upright.
Remove the batteries from the computer if you will not be using the
device for more than 4 weeks. Choose a dry storage location in the
house. Cover the device to protect it from discoloration caused by
sunlight and dust.
3. Checks
We recommend checking the screw connections made during
assembly to ensure they are tight every 50 hours of operation.
TROUBLESHOOTING
If you cannot solve the problem with the following information, please contact the authorized service center.
Problem
Computer has no value at
Display if you press any key.
Computer is not counting data
and do not switch on after start
cycling.
Computer is not counting data
and do not switch on after start
cycling.
TRAINING SPACE REQUIREMENT
1960
420
Possible Cause
No Batteries insert or batteries empty
Sensor impulse missing base on not well
plugged connection
Sensor impulse missing base on not correct
position of sensor.
Training area in mm
(for home trainer and
user)
2000
76
Solution
Check the position of batteries at battery compartment or
replace batteries.
Check the plug connections at
computer and under the fold up constrcution.
Check the distance from the sensor to the magnet. A magnet is
attached to the drawstring winding and should pass the sensors
at a distance of less than < 5mm.
2560
17
21
Free area in mm
(Training area and security
area (circulating 600mm))
2000
1620
GB