EUROM Heat and Beat Manuel D'utilisation page 26

The Eurom Heat and Beat infrared heater consists of:
1. Heater with suspension bracket (11),
electrical cable and plug
2. Wall bracket (2x) with wing nut (3)
for fastening. Use a wing nut for
securing the bracket.
3. Three brackets (various sizes) for
suspension to tent frame, parasol or
similar item, with two wing nuts
4. A set of chains with 2x2 karabiner
hooks for ceiling suspension
5. on / off switch
6. reset button
7. 2 separate Bluetooth antennas:
a) Warmth & light
b) sound
8. Speaker (2x)
9. LED lighting (2x2)
and a remote control
and fastening material.
The Eurom Heat and Beat is equipped with
a top quality 2000W Golden Amber ULG
lamp that produces 90% less light.
Alongside the comfortable 2000W heat,
the Golden ULG lamp also emits a natural,
warm, subtle glow. The lamp has an
expected life of 8,000 hours; under normal
circumstances, it should not have to be
replaced.
Very intensive use can lead to precocious
aging of the lamp and of course an
accident can break it. In that case, contact
your dealer or a qualified electrician. The
lamp has a special connection and it is not
allowed to not-qualified people to remove
or change it.
Installation
Caution! The model in the photo may differ from the model you have purchased.
Both models are installed in the same way.
Before installing, secure the hanging bracket (11) to the heater. Using the Allen
key, undo the Allen screw (12) and pull the pin with the other screw out of the
26