EUROM Heat and Beat Manuel D'utilisation page 28

2. Suspension from a frame (parasol, tent or similar item) by means of a bracket
 Ascertain that the frame from which you wish to
suspend the terrace heater is strong enough to
take the weight of the terrace heater for an
extended period of time.
 Choose which of the three supplied brackets is
suitable for the frame. You must choose the
smallest possible option.
 Slide the bracket around the frame, place the
terrace heater against it and screw the bracket
to the suspension bracket with 2 wing nuts (see
picture).
3. Suspension from a ceiling by means of chains
 Choose 2 suspension points in the ceiling, 40 cm
apart. Ascertain that the ceiling and fastening
materials are strong enough and suitable to take
the weight of the heater for an extended period
of time.
 Fasten the suspension eyes to the ceiling (not
supplied).
 Hook one end of the chains onto suspension
points of the heater by means of the karabiner
hook. You hook the karabiner hooks at the other
end of the chain through the suspension eyes in
the ceiling.
suspension eye
karabiner hook to the chain allows you to raise the suspension height of the
heater. You can also wrap the chain around a horizontal beam or rod (see
picture).
Please always take account of the minimum distances to the ceiling, floor, walls
and objects and make sure the heater is horizontal!
The following applies for all options
 However you install the Eurom Heat and Beat, always lead the electrical cable
directly away from the heater. It may not become hot!
 Adjust the desire radiation angle of the device. Do this by
undoing both Allen screws slightly using the Allen key.
Make sure you secure them again once you have made the
adjustments! The heater can rotate through approximately
60°; the recommended beam angle is 45°, see image.
When adjusting the angle ensure that the radiator does
not radiate heat onto flammable materials from a short
distance!
 Fasten all screws another time firmly and scheck or the
heater is firmly mounted. Now your infra red heater is ready for use.
Pulling the chain
and fastening
through the
the second
28