complete with protection guard. Top cutter rotation speed is 130 rpm approx. Transmission : single speed or single speed+reverse speed. Weight of
the complete motor hoe is 44 kg. Motor hoe dimensions: max length 1.30 m max width 0.50 m height 1.10 m.
NOISE AND VIBRATION LEVEL
Measured sound pressure level with En709, Leq = 77,3 dB (A), with a uncertainty value K = ±1,1 dB (A) for MZP05 and Leq = 83 dB (A), with a
uncertainty value K = ±1,2 dB (A) for MZP06. Handlebar vibration in compliance with EN 709 and ISO 5349. Level max detected = 7,2 m/s
value K = ±3,6 m/s
for MZP05; level max detected = 8,6 m/s
2
ACCESSORIES FOR MOTOR-HOE MZP05
blower. 4) 16 cm cutter.
ACCESSORIES FOR MOTOR-HOE MZP06
cutter widening with guard.
TROUBLESHOOTING
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
FAULT
The engine does not start
The engine power goes down
The tines are not rotating
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
Measured sound power level with En709, Lwa = 92 dB (A), with a uncertainty value K = ±1 dB (A).
, uncertainty value K = ±4,3 m/s
2
1) Fixed-wing ridger with coupling. 2) Spring lawn weeder complete with guard. 3) Blade
1) Fixed-wing ridger with coupling. 2) Spring lawn weeder complete with guard. 3) 75 cm
FAULT CLEARANCE
Check the fuel level, if necessary refuel.
Check the throttle to be on START position.
Check the spark-plug connector to be properly attacched.
Check the spark-plug condition and if necessary replace it.
Check the fuel valve to be in the opened position (only for the models showing
such feature).
The air filter is dirty – please clean it.
Check if any stone or soil/vegetation residue is stopping the tines rotation, in
case clean them.
Adjust the transmission cables registers.
Check the tines to be fasten to the shaft.
Check the transmission belts position and condition : realign position and/or
replace them.
for MZP06.
2
EN
, uncertainty
2
17