Eurosystems Z3 Mode D'emploi page 16

START. For cold starting, refer to the motor booklet. Grip the start handle and give a strong pull.
- Forward speed (fig. 6) : grip the handlebars and press the safety device (13) which is preventing the accidental tines connection. Pull the forward
lever (2) all its way long.
EN
- Reverse speed (fig. 6): release the forward control lever (Fig.6, part 2) and after having unlocked the device (A) in the direction shown by the arrow
moving it from the position (Fig. 6.1) to the position (Fig. 6.2), pull towards you the other lever (1) on the handle.
ATTENTION: It is important that when the device (A) is in the locked position (Fig. 6.1) the machine does not move. If this does not happen, adjust
appropriately the cables, as explained in the SETTING THE CONTROLS chapter (Fig.6).This motor hoe has been designed to produce minimum
vibrations and noise. Nevertheless, it is a good idea to interrupt long jobs with short pauses.
- End of work: after work, to stop the motor, move the accelerator lever (fig. 5 part 2) to STOP position.
CHANGING THE OIL IN THE LOWER DRIVE (Fig. 9)
viscosity SAE 80 ). Proceed as follows: A) loosen the screw cap (1). B) place the machine at an angle and suck up the oil using a syringe. C) fill up
with about 0.2 litres of new oil for the model of motor hoe with width 40 cm; about 0.5 litres for the model of motor hoe with width 50 cm.
To check the oil level: Place the machine in horizontal position; unscrew the cap and make sure the oil is at the lowest level of the hole. The filler
and emptying cap corresponds to the level of the oil.
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.
SERVICING FOR THE HOE TILLERS
residues, grass, iron wires, etc. etc.
MAINTENANCE ENGINE (see engine manual)
level and using the type of oil indicated in the engine manual.
GARAGING AND SCHEDULED MAINTENANCE
a good machine working on safety conditions. Leave the machine to cool before garaging anyhow don't room it if the tank still contains some fuel as
the vapours could reach some blazes or sparks. The fuel tank is to be drained outdoors only. To lower the fire danger , keep the engine , the silencer
and the fuel area free from leaves , grass or greasy substances.
DESCRIPTION OF THE MACHINE COMPONENTS (Fig. 8)
gear control lever. 4) Motor pull-start handle. 5) Cutting adjustment drewbar. 6) Cutters. 7) Cutter guard. 8) Plant protection discs (for MZP06 only).
TECHNICAL DETAILS OF MOTOR HOE MZP05
complete with protection guard. Top cutter rotation speed is 120 rpm approx. Transmission : single speed or single speed+reverse speed. Weight of
the complete motor hoe is 32 kg. Motor hoe dimensions: max length 1.30 m max width 0.40 m height 1.10 m.
16
TECHNICAL DETAILS OF MOTOR HOE MZP06
Generally speaking, the oil should be changed every 100 work hours (oil
Clean the tiller hubs, the tiller-shaft and the cutting hoe parts making sure they are free from soil
Attention - The motor-hoe is delivered without oil in engine. Fill the tank up to the
Keep attention that all the nuts, screws and bolts are tightened in order to guarantee
1) Accelerator control lever. 2) Hoeing start control lever. 3) Reverse
Motor: for details, see the specific publication. Working width of cutters is 40 cm,
Motor: for details, see the specific publication. Working width of cutters is 50 cm,