Publicité
Les langues disponibles
Les langues disponibles
7.3
Rotor detection
7.4
Cooling (for centrifuges with cooling)
7.4.1
Instructions, cooling
7.4.2
Standby cooling
7.4.3
Precooling the rotor
Starting
AB2200en
3.
If required: Press the
and set it with the
The parameters t/min and t/sec must be set to 0 with the
knob] to set continuous operation. Continuous operation is shown in
'¥' .
the indicator with
[SELECT] button to select the 'PROG STO' parameter.
4.
Use the
[Rotary knob] to set the desired program location.
5.
Use the
[START/IMPULS] button.
6.
Press the
�� Settings are stored in the desired program location.
'*** ok ***' is displayed briefly.
The settings are always stored in program location # if the
IMPULS] button is pressed without the 'PROG STO' parameter
being selected.
■
Rotor detection is performed after starting a centrifugation run.
■
If the rotor has been changed, the centrifugation run is cancelled after
rotor detection. The rotor code (R) and the maximum rotor speed (n-
max) of the newly detected rotor are displayed.
■
If the maximum speed of the rotor used is less than the set speed, the
speed is limited to the maximum rotor speed.
The temperature setpoint can be adjusted from -20 °C to +40 °C.
The lowest achievable temperature is rotor dependent.
After a centrifugation run, standby cooling is delayed and the display shows
'Lid unlocked' .
The delay time is adjustable from 1 to 5 minutes, in 1-minute increments. It
is preset to 1 minute.
■
The rotor is stationary.
■
The lid is open
1.
Press and hold the
't/min = X ' is displayed after 8 seconds.
��
[Rotary knob] to set the delay time.
2.
Use the
[START/IMPULS] button.
3.
Press the
�� The setting is stored.
'*** ok ***' is displayed briefly.
[STOP/OPEN] button twice or wait 8 seconds to exit the
4.
Press the
menu.
The rotor is stationary.
[Cooling] button.
1.
Press the
Rev.: 15 / 01.2024
[SELECT] button to select the desired parameter
[Rotary knob] .
[Cooling] button.
Software operation
[Rotary
[START/
29 / 39
Publicité
