Transporting; Advice On How To Obtain A Good Cut - Dolmar TM-92.14-H Manuel D'utilisation

HOW TO USE THE MACHINE
Control of the machine may be lost, particularly on slippery surfaces.
➤
For mechanical drive models:
DANGER!
!
with the clutch out! Always engage a low gear before leaving the
machine stopped and unattended.
➤
For hydrostatic drive models:
Go down slopes without touching the pedal (☛ 4.32) to take advantage of the
braking effect of the hydrostatic drive when the transmission is not engaged.

5.6 TRANSPORTING

WARNING!
!
suitable equipment for lifting and an appropriate number of people for
the weight involved and the type of lifting system used. The machine
must never be lifted by rope and tackle. While being transported, close
the fuel stopcock (
ing brake and fasten the machine securely with ropes or chains to the
hauling device.

5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT

1. To keep a lawn green and soft with a good appearance it should be cut regu-
larly without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blades must be in good condition and well sharpened so that the grass is
cut straight without any ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass
and to get the necessary thrust to push the cuttings through the collector chan-
nel.
5. The frequency of mowing should be in relation to the rate of growth of the
Never ride the machine on slopes in neutral gear or
If the machine is transported on a truck or trailer, use
➤
if fitted), lower the cutting deck, engage the park-
EN 33