Dolmar TM-92.14-H Manuel D'utilisation page 80

EN 28
– engage the parking brake on slopes;
– pull out the lever (1) and tip up the grass-
catcher to empty it;
– close up the grass-catcher so that it hooks
onto the pawl (2).
NOTE
warning may be heard at the moment of
engaging the blade even when the grass-
catcher has been emptied. This is due to
grass-cuttings left on the sensor (3) of the
micro-switch. To stop the signal, disengage
the blade and then immediately engage it
again.
Always keep the sensor (3) free of grass-cut-
tings.
5.4.7 U
NBLOCKING THE COLLECTOR CHANNEL
Cutting very tall or wet grass, particularly at too high speed, can cause the col-
lector channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades and stop the
engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit of the collector
channel.
WARNING!
!
off.
5.4.8 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed
and ride the machine with the cutting deck in the highest position.
At times the audible
This job must only be performed with the engine turned
HOW TO USE THE MACHINE
1
2
3