Dolmar TM-92.14-H Manuel D'utilisation page 78

EN 26
WARNING!
!
( ☛ 4.32) to prevent sudden engagement from causing tipping up and loss
of control of the vehicle, particularly on slopes.
5.4.3 B
RAKING
First, reduce the machine's speed by reducing the engine's r.p.m. and then push
the brake pedal (☛ 4.21 or 4.31) to further reduce the speed until the machine
stops.
➤
For hydrostatic drive models:
NOTE
releasing the drive pedal.
5.4.4 R
EVERSE
Reverse must be engaged ONLY when the machine is stopped.
➤
For mechanical drive models:
Push down the pedal until the machine stops and then go into reverse by
moving the lever sideways and putting it into position «R» (☛ 4.22). Gradually
release the pedal to engage the clutch and then begin moving in reverse.
➤
For hydrostatic drive models:
When the machine is stopped, start the reverse movement by pressing the
drive pedal in the «R» direction (☛ 4.32).
5.4.5 G
RASS CUTTING
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– engage the blades (☛ 4.9);
Drive must be engaged in the way already described
The machine already slows down considerably by just
HOW TO USE THE MACHINE