Dolmar TM-92.14-H Manuel D'utilisation page 94

EN 42
should always be 5 - 6 mm lower than the
rear.
– Put the machine onto a flat surface and
check the tyre pressures;
– put 26 mm blocks (1) under the front edge of
the deck and 32 mm blocks (2) under the
rear edge, and then put the lifting lever into
position «1»;
– fully loosen the adjuster (3), the nuts (4 – 6 –
8) and the locknuts (5 – 7 – 9) of the three
trace rods until the deck is resting on the
blocks;
– screw the two upper right nuts (6 – 8) and
the lower left nut (4) until the deck starts ris-
ing; tighten the three locknuts (5 – 7 – 9) and
turn the adjuster (3) until the control cable is
taut.
Any difference in height from the ground
between the right and left side of the deck can
be compensated by turning the two nuts (4 – 8)
and locknuts (5 – 9) of just the back rods.
Move the control lever to 2 or 3 different positions, making sure that the deck
rises evenly and that the difference in height from the ground remains the same
between the front and rear edge.
If the front part rises too early or too late, you can regulate the movement by
turning the nuts (10) on the connecting rod (11).
Screwing the nuts on the rod makes the rear part rise earlier, while unscrewing
them does the opposite.
Always remember to fully tighten all the nuts and locknuts when the adjustment
has been made.
If you are unable to get the cutting deck adjusted properly, consult a Licensed
Service Centre.
1 - h = 26 mm
9
5
8
4
11
6
7
MAINTENANCE
2 - h = 32 mm
3
10