Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Touch
on the Run
display to start formula in-
tervention. Controls in the
Names and Timers area
and the Machine Status
area of the Run display
become active so that you
can change the formula in
progress. Green boxes on
the display identify the
formula control areas, or
the settings that can be
changed, as shown in
ure 15, page
24.
NOTE: A pass-
word may be re-
quired to use
formula
intervention.
In formula intervention
mode, touch a box to dis-
play the pop-up controls
for that setting. The pop-
up controls available cor-
respond with your ma-
chine's equipment and your configuration decisions.
NOTICE: The MilTouch™ controller prevents the activation of certain controls when
their activation would be inappropriate. For example, the controls for the water valves are
not available when the bath water is at its maximum level.
Modify Step Timer
Figure 16. Pop-up Controls for Step Timer
Add 1 minute to the remaining step time.
Subtract 1 minute from the remaining step time. If there is less than 1 minute remaining
on the step timer, the timer is reduced to 00:00 and the controller moves on to the next phase
in the current step, or the next step if there are no more phases.
24
Figure 15. Formula Control Areas
Fig-
Cylinder speed controls
C.
Cancel the formula
Ca.
Drain and reuse controls
D.
E.
End formula intervention
H/C. Heat and cool (steam and cooldown) controls
Lw.
Bath level controls
St.
Step timer controls
Tw.
Bath temperature controls
W.
Water valve controls
— Touch the box identified by item St on
Legend
Figure 15, page
Pellerin Milnor Corporation
24.
Publicité
