Abicor Binzel xFUME ADVANCED HP 230V CSA Mode D'emploi D'origine page 15

xFUME™ ADVANCED HP 230V – CSA
The following fume collection devices can be connected to the unit:
– Fume extraction torch
– Welding torches with external fume extraction systems
– Funnel-shaped nozzle with magnetic bracket
4.2 Control elements and connections
Figure 3 Operator Controls and Connections
Service LED
A
Power LED
C
<Auto/Manual> switch
E
Power supply cable
G
Fuse
I
Current clamp port 2
K
<Auto/Manual> switch
Power LED
Service LED
BAL.0814.0 • V01
A B C
K J I
Operation LED
B
Hour meter
D
<ON/OFF> switch
F
Output regulator
H
Current clamp port 1
J
The automatic start/stop mechanism is activated when the
switch is set to <Auto>. If the switch is set to <Manual>, the
automatic start/stop mechanism is inactive and the device
must be switched on and off manually.
The power LED illuminates continuously if the device has
been switched on by the <On/Off> switch.
There is a safety device for monitoring the minimum air
volume to be extracted installed in the unit. A differential
pressure sensor is used for monitoring purposes. The service
LED illuminates in continuously when both filter cartridges are
not functioning properly or are saturated and must be
replaced. During initialization, the power LED and the
service LED flash alternately.
4 Product description
D E F
H G
EN - 15