Maintenance And Care - Festo SLTE Notice D'utilisation

SLTE
8

Maintenance and care

Warning
Danger of injury from shearing, squeezing and abrading
After failure or malfunction of the control system or after interruption and resto
ration of the power supply, there may be positioning motions on the slide. This
may cause injuries.
S Make sure that the slide is secured against moving when it is in the
de−energised state.
Switch off the power supplies.
S
Note
Liquid cleaning agents such as water can damage the sliding bearing material
and the electronics.
S If necessary, clean the SLTE with a soft dry cloth.
Lubrication:
Grease the surfaces of the roller bearing guide which do not have a layer of
S
grease in accordance with the following table:
Component
Lubrication interval
Lubricating point
Lubricating procedure
Lubricating grease
Fig. 14
Check whether lubrication is required more often.
S
This may be necessary in case of:
high thermal load or excessive accumulation of dirt
fat solvent fluids or fumes in the vicinity.
Festo SLTE 0910a English
Ungreased surface
of drive rod 1
As required (e.g. after cleaning)
Drive rod
Push the slide backwards and forwards by hand when
lubricating (equal distribution of grease)
LUB−KB1
Roller bearing
of slide 3
Guide rail
LUB−KC1
37