Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Before starting the desired cycle, by pressing
within the blue coloured area for refrigeration it is
GB
possible to access the setpoint editing functions.
To change the temperature and relative humidity
values, press the
scroll bar icon. Press
values or press
return to the previous level without saving.
To start the manual cycle press
following screen will be displayed:
During the manual cycle, the control keys are
displayed at the bottom of the screen. They
correspond to following features:
: turns the light on and off
manual settings (for setpoint editing and
manual defrost activation)
and
keys or drag the
to confirm the new set
to quit the procedure and
. The
: display of inputs / outputs and alarms
: if pressed for 3 seconds, it interrupts the
manual cycle.
The manual cycle has no duration settings,
it can only be terminated manually by pressing the
key.
After a default inactivity time, the system goes into
"SCREEN SAVER" mode; the display shows the
values detected by the probes in use.
Just touch the screen to exit the "SCREEN
SAVER" mode. Even the progression of an alarm
may interrupt the "SCREEN SAVER" mode.
During the execution of a cycle, the mode of the
main utilities is displayed by icons on the top of
the screen. Below, their meaning when powered:
compressor on
heating on
funs on
defrosting on
humidification in progress
dehumidification in progress
alarm in progress
8
Publicité
