Parkside 311369 1904 Traduction Des Instructions D'origine page 52

CAUTION!
► If no tool is inserted into the collet chuck
tighten the collet chuck nut
it on by hand only!
Using the grinding drum for grinding belts
♦ First undo the nut on the grinding drum
clockwise with the help of the assembly tool
Hold the grinding drum in place with a pipe wrench.
♦ Place the abrasive belt
♦ Tighten the nut on the grinding drum
wise using the assembly tool
Hold the grinding drum in place again with a pipe wrench.
♦ Insert the grinding drum
Switching on and off
Switching on
♦ First, press the trigger lock
down to switch the tool on.
Switching off
♦ Release the trigger
♦ When you have finished working, disconnect the tool from the
compressed air source.
PDSS 16 A1
with the assembly tool
completely on the grinding drum
10a
to fix the abrasive belt.
in the collet chuck
forwards and then the trigger
.
/ , do not
by turning it
.
by turning it anticlock-
as described.
GB │ IE │
, screw
.
49 ■