Parkside 311369 1904 Traduction Des Instructions D'origine page 51

CAUTION!
► Ensure that the compressed air hose is firmly attached. A loose
hose can thrash about uncontrollably causing grave danger.
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance.
♦ The compressed air source must be equipped with a pressure re-
ducer so that you can regulate the air pressure.
Operation
Changing/inserting the tool/collet chuck
CAUTION!
► The shaft diameter of the tool must exactly match the clamp
bore of the collet chuck
NOTE
► Use the grinding bits
or fine work on hard materials such as metals.
► Use the grinding belts
wood, plastic or putty.
♦ Hold the spindle
♦ Unscrew the collet chuck nut
bly tool .
♦ Insert the tool into the collet chuck
♦ Hold the spindle
♦ Tighten the collet chuck nut
■ Ensure the accessory tool is firmly attached.
│ GB │ IE
■ 48
/ (Ø 6.35 mm/3.2mm)!
for grinding work on stone, wood
for sanding work, for example on
10a
using the assembly tool
from the thread using the assem-
using the assembly tool
using the assembly tool
.
/ .
.
PDSS 16 A1
.