Parkside PHS 600 A1 Traduction Des Instructions D'origine page 31

Trouble Shooting
Problem
Device does not start
Device runs with inter-
ruptions
Blades become hot
Spare Parts/Accessories
Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone (see
"Service-Center" Page 33). Please have the order number mentioned below ready.
Position Position
instruction exploded
manual drawing
2 62
3 53
26-28
10 1
Possible cause
Mains voltage not on
On/Off switch (
deadman switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
deadman switch (
defective
Blades ( 2) are blunt
Blades ( 2) are notched
Too much friction due to
lack of lubrication
www.grizzly-service.eu
Description
Cutter bar
Hand protection
Carbon brushes + support
Blade protection
Fault correction
Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
6) or
4)
Repair by Service Centre
Check the cable and have it
changed by the Service Centre if
necessary
Repair by Service Centre
6) or
4)
Have the blades sharpened or
replaced (Service Centre)
Have the blades checked or re-
placed (Service Centre)
Oil the blades (
GB IE
2)
Order No.
91102942
91105451
91105450
91102941
31