Publicité
Les langues disponibles
Les langues disponibles
Before installation ensure that the circuit, to which the
product will be connected, is not energised. To do so,
remove the fuse or switch off the circuit breaker in the
fuse box (0 position) (see fig. A).
Use the voltage tester to verify the de-energised status.
The included mounting material is suitable for ordinary
solid concrete or masonry construction. Check which
mounting material is suitable for your chosen mounting
surface. If necessary, seek expert advice.
Installation
Make sure you will not be drilling into electrical, gas or water
lines inside the wall. Use a power drill to drill the holes into
the brick wall. Always observe all safety instructions for the
power drill in the manual for the power drill. Death or injury
due to electric shock may otherwise result.
When selecting the mounting location, pay attention to
the following:
Make sure that the product illuminates the desired area
(a height of 1.8–2.5 m is ideal).
Make sure the twilight sensor
minated at night by street lighting or garden light. This
can influence its functioning. If the brightness is lower
than a preset value (approx. 40 lux, i.e. at dusk) the
product will switch on automatically.
Remove the fixing screws
visible on the lamp body
housing
5
the connection housing
fig. B).
22 GB/IE
. Then take out the terminal block
5
(see fig. I) is not illu-
13
and silicone washers
3
and open the connection
2
for easy installation (see
4
from
12
Publicité
