LIVARNO LUX HG05047B Instructions De Montage, D'utilisation Et Consignes De Sécurité page 21

DANGER OF INJURY! Check any LED bulb for dam-
age immediately after unpacking. Do not fit a defective
LED bulb into the product.
before you touch it. In this way you will avoid the dan-
ger of burns. LED bulbs develop a great deal of heat.
Replace a defective bulb immediately. Before replacing
the LED bulb always switch off the electricity supply of
the product.
Allow the product to cool for at least 15 minutes before
replacing a defective LED bulb.
The product continues to draw a small amount of power
even if the product is off as long as product is connected
to supply mains. To switch the device off completely,
the mains switch should be switched off.
Never use your product if you discover that it is dam-
aged in any way.
Do not use this product for dimmers or electronic switches.
It is not suitable for these purposes.
Before installation
Note: Remove all packaging materials from the product.
Important: The electrical connection must be established
by a qualified electrician or a person trained to perform
electrical installations. This person must be familiar with the
properties of the product and the connection regulations.
Please note the LED bulb is not dimmable.
CAUTION! DANGER OF BURNS DUE
TO HOT SURFACES! Ensure the product
has been switched off and allowed to cool
GB/IE 21