Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 7

Using an Ethernet Switch
If this is your first time setting up a 10G network for streaming ST 2110 IP video, there are few
considerations you should take into account when getting started. IP media is sent in packets,
so it's important to have a PTP aware switch to provide the timing information to synchronize
the devices connected to the network. The management of the traffic flow is covered by a
separate control system named NMOS that can be added to the network via either a software
or hardware solution.
SDI
OUT
SDI
IN
ETHE
RNET
+12V 6 K
+12V
SDI
SDI Program
Return Feed
Connecting to a Network Switch
Your network switch needs to be a managed 10G network switch that supports IGMP version
3 snooping.
Managed switches provide monitoring and control of traffic over the network and require
configuration to get started. The size of you network switch depends on how much traffic you
might need. For instance, an 8 port 10G Ethernet switch has a capacity of 160Gbps and a 16
port switch will allow up to 320Gbps.
The following 10G network switches have been tested with Blackmagic 2110 IP converters:
Manufacturer
Ubiquiti
Netgear
Netgear
Netgear
Ethernet
Model
Enterprise XG-24
M4300-96X
M4350-40X4C
M4350-16V4C
HDMI
Using an Ethernet Switch 7