Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 28

Reference Output
The dedicated reference out BNC connection on the rear lets you set the timing for other
devices connected to your Blackmagic 2110 IP Converter 3x3G. You can set your output
standard to SD or HD using the list selection.
Factory Reset
Highlight 'factory reset' in the setup menu to restore your Blackmagic 2110 IP Converter 3x3G to
factory settings. Once you press 'set', you will be prompted to confirm your selection.
Rear Panel
1
1 Power
IEC C14 connector for 90 – 240 volt AC power supply.
2 SDI Out
3G-SDI video output BNC connectors.
3 SDI Loop Out
3G-SDI video loop output BNC connectors.
4 10G Ethernet PoE+
Blackmagic 2110 IP Converter 3x3G can be connected point to point or via a managed 10G
IGMP network switch.
5 Ref Out
Your Blackmagic 2110 IP Converter 3x3G features a stabilized video reference output
corresponding to standard definition black burst and high definition tri-sync standards. For more
information on selecting your reference output, refer to the 'settings' section earlier in this manual.
6 SDI In
3G-SDI video input BNC connectors.
2
4 5
3
6
Rear Panel 28