Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 5

Getting Started
SMPTE ST 2110 IP is an Ethernet based broadcast solution that lets you stream video, audio
and data signals over a network. Blackmagic 2110 IP converters are 10G converters you can
use to adapt your existing SDI equipment, including cameras, switchers, monitors and disk
recorders, to fit into a 2110 IP workflow. Plus, these converters can connect directly to each
other, so you can start using 2110 IP without needing any prior IT or networking knowledge.
Getting started with Blackmagic 2110 IP converters is as simple as connecting power, adding
your SDI source and destination and then connecting the two converters directly using a
Cat 6 Ethernet cable.
SDI
SDI
OUT
SDI
IN
+12
V
This illustration shows a point to point connection between two Blackmagic 2110 IP Mini
converters. The camera SDI out is connected to the SDI in on the Blackmagic 2110 IP Mini
BiDirect 12G and the Blackmagic 2110 IP Mini IP to HDMI is connected to the HDMI television.
These two converters are connected point to point by a Cat 6 Ethernet cable.
Plugging in Power
To power your Blackmagic 2110 IP Mini converter, plug the supplied power adapter into the
power input on the rear panel. Tightening the locking ring secures the power cable to prevent
accidental disconnection. Once powered, the LED beside the power connector will illuminate.
Ethernet
HDMI
Getting Started 5