Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 27

Date
To enter the date manually, select the date field and press set. Using the menu dial you can
select the day, month and year.
Time
To adjust the time, select time and press set. Use the menu dial to adjust the hours and minutes.
The internal clock is a 24 hour clock.
Network Settings
Protocol
Your Blackmagic 2110 IP Converter 3x3G is shipped set to static IP, so once connected, you can
assign an IP address. To change to DHCP, highlight the protocol option and press 'set'.
IP Address, Subnet Mask and Gateway
When Static IP is selected you need to enter your network details manually.
To change the IP address
1 Rotate the menu dial to highlight 'IP address' and press the flashing 'set' button on your
converter's front panel.
2 With a set of numbers underlined, press the 'set' button to highlight and rotate the menu
dial clockwise to increase or counter clockwise to decrease.
3 Press 'set' to confirm the change and move to the next value.
When you have finished entering your IP address, you can repeat these steps to adjust the
subnet mask and gateway. Once finished, press the flashing 'menu' button to exit and return to
the home screen.
2110 Multicast Output
Each streaming output is assigned a different multicast output address.
This setting is similar to an IP address and lets other SMPTE 2110 IP equipment identify the
stream on your network. Each stream from your converter requires its own multicast output
address. NMOS controllers will also display the audio and ancillary data multicast addresses
associated with each source.
Settings 27