Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 29

Blackmagic Converters Setup Settings
In Blackmagic Converters Setup there are additional settings available for Blackmagic 2110 IP
Converter 3x3G models to set labels for the inputs and outputs and to save label sets.
Inputs
Use the inputs tab to label the connected SDI inputs. The NMOS protocol broadcasts these
labels to make identifying them via an NMOS controller or other Blackmagic 2110 IP Converter
3x3G easy.
Outputs
Use the outputs tab to label the SDI outputs. For example, if SDI output 2 is connected to a
HyperDeck Studio HD Plus, enter 'HyperDeck HD Plus' in the output 2 field. If you are using an
NMOS controller to route your sources and destinations, you can select 'HyperDeck HD Plus'
from the destination selection tab.
Labels
You can also save or load label sets using the cog icon in the lower left corner of the utility.
To save a label set, click on the save option and navigate to a location to save the file.
To load a label set, click on the load option and navigate to the location of your label set.
Once selected, click open.
Installing into a Blackmagic Universal Rack Shelf
Your Blackmagic 2110 IP Converter 3x3G shares a compatible form factor with many other
Blackmagic Design units that can be mounted in a rack. The 'Blackmagic Universal Rack Shelf'
section later in this manual shows how to install the converter into the rack shelf.
Rear Panel 29