Blackmagic Design 2110 IP Manuel D'installation Et D'utilisation page 14

Ancillary Data Identifier
Blackmagic 2110 IP Converters support SMPTE-2110-40 ancillary data elementary streams.
This data can include closed captions, tally, timecode and metadata. The ancillary data identifier
table indicates the type of ancillary data that is present once added.
The ancillary information will be identified by a data identifier or DID and secondary data
identifier, or SDID. The converter includes common timecode and caption data, but you can
add up to three additional identifiers.
To add an additional ancillary data identifier to the list:
1 Click on the plus sign button to add a new row.
2 Enter a name for the data. This name will be visible when routing SMPTE streams using
an NMOS controller.
3 To disable any ancillary data, uncheck the corresponding box in the far right column.
Multicast Address
Each ST 2110 stream output from your Blackmagic 2110 IP converter uses a discrete multicast
address that can be found via the LCD menu. If you are using Blackmagic Converters Setup
you can view and modify the discrete address and port number for each elementary stream.
To change the multicast output address:
1 Select the output using the 'sending from' menu.
2 Tick the checkbox for auto or manual IP configuration.
3 Enter a new IP address and port number into the fields and click the save button at
the lower right of the utility.
Blackmagic Converters Setup 14