Publicité
Les langues disponibles
Les langues disponibles
Preparatory steps
1 2,5 4
1
POWER
6/I
A SPEAKERS B
/
/_
/
/
t
if
""//
i
f
! i \/f
7
A SPEAKERS B
n i f_ !
/_//i //
L
III
! II n M!
I
©
©
A SPEAKERS B
/_ /_// //I / /
/
! \ ! n M !
SFC MODE
III
1^ 1^ U
I
"
ill
III
I
Speaker settings
These settings should be done to get the most from the unit's
reproduction modes
pages 18-19),
Front, center, and surround channel settings
Set the DISTANCE for your speakers.
In DISTANCE
Enter the distance of each speaker from the listening position so
the sound from the speakers reaches the listening position at the
same time. The unit calculates the delay time for the center and
surround speakers based on these distances.
1
Press [POWER, 6/1]-
2
Press [A] and [B] at the same time.
"SETTING" appears on the display.
3
Press [A] to select "DISTANCE".
Each time the button is pressed the display switches as
follows.
SIZE —► DISTANCE —► FILTER —^ DR COMP
t_I
4
® Press [B] to select the speaker
channel to be set.
Each time the button is pressed the display switches as
follows.
FRONT-►CENTER-► SURROUND .
t_I
d) Turn [SFC MODE] to set the
distance.
Distance can be set at 1 foot intervals between 3 feet
to 30 feet.
The factory settings are as follows.
Front and center speakers:
10 FEET
Surround speakers:
5 FEET
(D Repeat steps ® and d) to complete
the distance settings for the front,
center and surround speakers.
5
Press [A] and [B] at the same time.
"COMPLETE" appears on the display.
If you allow about 10 seconds to elapse between settings, the
procedure is cancelled, all settings are returned to how they were,
and the previous display is restored. Begin again if this occurs.
/
/
ll\/ll_ll
/_
/ /
////////
/ /■
For your reference:
The settings remain as they are until changed by the above
procedure, even after the power has been turned off.
Other settings are necessary if you replace the
speakers
pages 38-39).
16
RQT5307
Publicité
